Art's-Way Manufacturing JR Series, Руководство оператора

Страница: 19 / 44

PREPAIRING THE GRINDER MIXER FOR OPERATION 17
Figure 14 - Grinder Attached To The Tractor With
Safety Chain.
For Electronic Scale Indicator, plug the scale power
supply cord into the electrical outlet on the tractor
or to the battery on the mixer frame. (Wire power
cord to the battery as shown in
Error! Reference s
ource not found. )
IMPORTANT: On electronic scale applications, if a
bolt and nut are used in place of a hitch pin, the nut
must not be tightened to where it hits against the
underside of the weigh bar clevis.
Connect the PTO driveline to the tractor PTO shaft.
The PTO operating speed of the tractor and grinder
mixer must be the same. The tractor half of the PTO
is equipped with 6-splines for 540 RPM operation.
H
AMMER MILL
Make sure the grinder mixer is equipped with a 540
RPM drive when operating with a tractor equipped
with a 5400 RPM PTO drive. The diameter of the
pulley on the jackshaft must be 23-5/8 inches for
540 RPM operation in a hammer mill application
(See Figure 15).
CAUTION: NEVER OPERATE A 540 RPM
GRINDER MIXER WITH A 1000 RPM
TRACTOR.
Figure 15
– Large Pulley - 540 RPM (Shields Removed
For Clarity).
After connecting the PTO driveline to the tractor,
anchor the driveline implement shield chain,
located in the main shield base slot, and the tractor
shield chain to the tractor drawbar.
B
EFORE
G
RINDING
New machines should be operated before
preparing feed. A few hundred pounds of
coarse material such as shelled corn or ground
cobs should be ran through the grinder mixer.
This will remove the protective oil coating from
the mixer cone and any metal particles that may
be in the machine. This will help polish the cone
and prevent bridging. After several minutes of
running the grinder mixer, unload the mixture
and discard.
Do not feed this mixture to the
livestock.
D
ETACHING
F
ROM
T
HE
T
RACTOR
CAUTION: MAKE SURE THE TRACTOR
IS SHUT OFF, REMOVE THE KEY AND
PLACE THE KEY IN YOUR POCKET.
IMPORTANT: Make sure the auger feeder are in
the saddle before disconnecting.
Disconnect the PTO driveline and front shield
anchor chain from the tractor and place it on the
PTO driveline support bracket (See Figure 16). The
PTO driveline support should be tight enough to
remain in position when rotated from storage
against the frame to use position.
Disconnect the electronic scale power cord from the
tractor (if equipped).
Disconnect the hydraulic hoses from the tractor
outlets.
Block the tires. Lower the jack stand to the ground.
Turn the handle of the jack stand to raise the grinder
mixer tongue off of the tractor hitch. Remove the
hitch pin and safety chain.
Figure 16 - PTO Support.
23-5/8
”