ARTEX PRODUCTS / ACR ELECTRONICS, INC
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
C406-2 (453-5000), C406-2HM (453-5001)
570-5000 Rev. U
Company Confidential
25-62-11
Page 62 of 66
TASK 25-62-11-990-803
3.
Explanation of Detailed Parts List Entries
SUBTASK 25-62-11-990-001
A.
Fig # & Item Column
1)
The first number at the top of the column is the figure number of the corresponding illustration.
2)
The right hand number is the item number in the associated figure.
3)
A dash (
–
) in front of an item means the part is not illustrated.
4)
Alpha-variants A through Z (except I and O) are assigned to item numbers, when necessary to
identify added parts, alternate parts, and service bulletin modified parts.
SUBTASK 25-62-11-990-002
B.
Part # Column
1)
This column contains the manufacturer’s part number for each part.
SUBTASK 25-62-11-990-003
C.
Nomenclature Column
1)
This column contains descriptive nomenclature for each part, service bulletin numbers affecting the
part, and obsolete part numbers.
2)
The indenture system used in the “Nomenclature” column indicates the relationship of one part to
another, as follows:
1 2 3
End Item or Major Assembly ATTACHING PARTS
Attaching Parts for End Item or Major Assembly
***
. Detail Parts for End Item or Major Assembly
. Subassemblies ATTACHING PARTS
. Attaching Parts for Subassemblies
***
. . Detail Parts for Subassemblies ATTACHING PARTS
. . Attaching Parts for Detail Parts
***
3)
Assemblies, subassemblies, and detail parts subject to modification, deletion, addition, or
replacement by an issued service bulletin, are annotated to indicate both pre- and post- service
bulletin configurations. The term (PRE SB 2828
) in the “Nomenclature” column designates the
original configuration, and the term (POST SB 2828) identifies assemblies and parts after the
modification has been completed.
