Artesyn AXP1440, Инструкция по установке и эксплуатации, Страница: 70 / 156

Site Preparation
68 AXP1440 Installation and Use (6806800H23U )
Shipment Inspection
To inspect the shipment perform the following steps:
1. Verify that you have received all items of your shipment.
2. Compare the shipment thoroughly with the delivery note.
3. Visually inspect the shelf to ensure that all of the connector pins are straight, shrouds
are properly seated, screws are tight, and so on.
4. Check the rails for proper alignment.
5. Check that the air filter is properly installed.
6. Check that the cable connections are secure and properly fitted.
7. Check the EMI gaskets for damage.
8. Check the items listed above for damage and report any damage or differences to the
customer service at www.artesyn.com/computing .
9. Tighten loose screws before proceeding.
10. Remove the desiccant bags delivered together with the system and dispose of them
according to your country’s legislation.
11. Do not remove shipping frame stiffeners until positioning is complete and all bolts are
fully tightened. Mounting without frame stiffeners may cause warping of the chassis.
3.2.2 Site and Installation Planning
Planning basic site and installation requirements you have to consider the following issues:

Is adequate power for the AXP1440 system available?

Can the system be positioned in a way that -48 to -60V DC power source is easy to
reach?

Are racks with sufficient space to install the system available?
The system is thoroughly inspected before shipment. If any damage occurred during
transportation or any items are missing, please contact our customer's service
immediately.