1
The FiberLink 3500 Series of fiber optic transmission systems are ready for immediate use and do
not require any special tools or equipment. However, an Optical Power Meter, such as the FiberLink
6650, can be useful in determining optical loss budgets during your systems design and
maintenance.
The following instructions describe the typical installation procedure:
1. Connect the video source to the video input BNC connector on the transmitter unit.
2. Connect the video output cable to video output BNC connectors on the receiver unit.
3. Terminate any unused BNC output connector at 75 Ohms.
4. Connect the fiber optic cable to the transmitter and receiver units.
5. Connect the Universal Power Supply to the transmitter and receiver units. For box versions
using DC power, please refer to figure 1.
6. When power is applied, the green POWER LED should illuminate, indicating the presence of
operating power. The 3G/HD/SD RATE LED will give an indication as described in the Indicator
LED’s and Alarm Circuitry section of the manuall.
7. The system should now be operational.
Note: The Rack Card version has an additional red LED for indicating the presence of an alarm
condition (loss of signal). Refer to Indicator LED’s and Alarm Circuitry sections of this manual.
FiberLink® 3500 Series (One Way)
2 or 4 Channel 3G/HD/SD-SDI transmission over one or
two single mode or multimode fibers
INSTALLATION INSTRUCTIONS
Figure 1: Power Connector DC Input Polarity
9-24 Volts
AC or DC
(+) Positive
( - ) Negative
This Quick Start Guide is for the following FiberLink
models:
• 3512A transmitter
• 3513A receiver
• 3514 transmitter
• 3515 receiver
• 3522 transmitter
• 3523 receiver
• 3524 transmitter
• 3525 receiver
3514 Tx
3G/HD/SD-SDI
Source
3515 Rx
Fiber
Cable
3G/HD/SD-SDI
Source
3G/HD/SD-SDI
Source
3G/HD/SD-SDI
Source
SDI Displays or
SDI Equipment
QUICK START GUIDE
