10
XLR INPUT JACKS
The XLR Input jacks are Pin Two positive, Pin Three negative, and Pin
One is ground. This connection is for balanced connections.
EUROBLOCK BARRIER STRIP
Insert the wires, then snug down with the set screw. The entire barrier
strip can be removed for quick service without disconnecting the
individual wires.
EURO BLOCK DIAGRAM
AMP MODE SWITCH
The SLA-2 Amp Mode Switch allows you to choose between Stereo
Mode and Bridged Mono Mode. Make sure that power is off and that
your speakers are wired appropriately when changing this mode.
OUTPUT BINDING POST
The SLA-2 Outputs are multi-connection jacks. You can use banana
jacks, spade connectors or bare wire.
Bare Wire Connections
– loosen the red and black caps on the
binding posts (don’t completely remove). Strip back the wire insulation
½”, then insert the bare wire into the hole on the side of the plastic
assembly. Once it is in, screw the binding post cap down on the wire.
Be sure that the wire connected to one post does NOT come in contact
with that of another post.
-Ch2-
-Ch1-
+
+
_
_
