ARS Automation FlexiBowl 350, Инструкция по эксплуатации

Страница: 56 / 84

6-10
Instructions for use and warnings
CHAPTER 6 - Controls and use
6.3.3.2 Programming and handling with digital I/o
CAuTIon!
Disconnect the input connectors, if connected.
The program to modify the movement parameters of the FlexiBowl
®
is on the USB flash drive, sent with the system.
Proceed as follows for programming using the digital I/o :
step Action
1 Use the FlexiBowl
®
utility parameters supplied by ARS to set the default parameters.
2 Place the Ethernet-I/O switch on the control panel on I/O.
3 Turn the FlexiBowl
®
off and then on again.
4 Wait for the Ready/Fault LED to turn green, after about 2 seconds the FlexiBowl
®
will be in I/O mode.
The operating principle is as follows:
• Apply the command code to be made to Function Bits 0,1,2,3. Logic level 1 is given by applying 24V to the Function
Bit.
• Apply 24V to the Strobe (Pin 5) and the return (Pin 9) for a limited time (about 50ms);
• The Busy output is available between Pin 3 and 8 of the Output connector.
IMPoRTAnT!
The strobe signal is inhibited until the FlexiBowl has completed the current command.
The Busy output remains active until the current command has been completed.
IMPoRTAnT!
Operation of the second valve (Flip2 / Blow) is established by a variable in the program. This variable can
be set from the PC Utility, FlexiBowl
®
parameters. The second valve is set as Blow by default.
FunCTIon BITs InPuT CodInG TABlE:
Function Bits Command
3 2 1 0
0 0 0 0 Reset the Flexibowl Fault
0 0 0 1 Servo ON
0 0 1 0 Servo OFF
0 0 1 1 Backlight ON
0 1 0 0 Backlight OFF
0 1 0 1 Forward
0 1 1 0 Forward-Flip1
0 1 1 1 Forward-Valve2
1 0 0 0 Forward-Flip1-Valve2
1 0 0 1 Shake
1 0 1 0 Backward
1 0 1 1 Backward-Flip1
1 1 0 0 Backward-Valve2
1 1 0 1 Flip1
1 1 1 0 Valve2
1 1 1 1 Continuous Turn