Chapter 4
:
Installing and Connecting your Telephony Gateway
Connecting the Telephony Gateway
WARNING
Risk of injury or equipment damage
Connecting the Telephony Gateway to the home’s existing telephone wiring should only be
performed by a professional installer. Physical connections to the previous telephone
provider must be removed and the wiring must be checked; there must not be any voltage.
Cancelation of telephone service is not adequate. Failure to do so may result in loss of
service and/or permanent damage to the Telephony Gateway.
1.
Connect one end of the coax cable to the cable outlet or splitter, and the other end to
the Telephony Gateway’s Cable connector (6). Tighten the connections by hand, then
tighten an additional 1/8 turn with a wrench.
Note: For best performance, use high-quality coax cable and minimize or eliminate splitters
between the cable jack and the Telephony Gateway.
Release 24 STANDARD 1.1 March 2015
Touchstone TG2492 Telephony Gateway User Guide 22
Copyright ARRIS Enterprises, Inc. 2015. All Rights Reserved.