ARRI L Series, Руководство пользователя, Страница: 17 / 52

Power
17
Power
WARNING! For protection from electric shock, always
connect the product electrically to ground (earth)
when connected to AC power. The AC mains power
supply must be fitted with a fuse or circuit breaker
and ground-fault (earth-fault) protection.
IMPORTANT! Ensure that persons do not look at the
light emission aperture when the product is con-
nected to AC power. The product can light up sud-
denly. The high intensity of the product can cause eye
irritation or injury when not respecting the safety dis-
tance.
IMPORTANT! Always connect the product direct to
AC power. Do not connect it to a dimmer-system.
Doing so will damage the product.
AC power
The L10 has an auto-sensing switch-mode power supply that
automatically adapts to AC power at
90 - 264 V ~, 45 - 65 Hz (nom.).
Before you connect the L10 to AC power, check that:
• the dimmer knob at the fixture menu is set to 0%, and
• no DMX signal is present at the DMX-input of the L10.
You can hard-wire the L10 to a building electrical installation.
You can install a power plug that is suitable for the local power
outlets on the power cable. Socket outlets or external power
switches that supply the L10 with power must be located near
the product and easily accessible so that the L10 can easily be
disconnected from power.
The L10 requires a power input cable with a Neutrik
®
PowerCON
®
True1 NAC3FX-W cable connector. Cable
requirements are listed in section “Specification” on page 47.
ARRI offers power cables with PowerCON
®
cable connectors
and different plugs or bare ends (see “Accessories” on
page 48).
To insert and remove the PowerCON
®
cable connector
• Line up the raised key of the connector and the keyway of the
input socket. Insert the cable connector without force in the
power input socket.
To insert the cable connector:
• Turn it a full quarter-turn clockwise.
To remove the cable connector:
• Push the connector lock backwards and turn the cable con-
nector counter-clockwise. Pull the cable connector out of the
power input socket.