ARRI ARRIFLEX 435 ES, Инструкция по эксплуатации

Страница: 81 / 143

81
Accessories
Ensure that the fastening flaps are properly po-
sitioned in the camera housing before swinging
the FEM into place, otherwise they may catch
and be damaged!
• Swing the functional expansion module onto the camera
housing.
• Screw tight the fastening screw
➪ photo
on the functional
expansion module.
External Synchronization Unit ESU-1
The use of the ESU-1 ➪ photo is only possible with the
function expansion module attached to the camera. The
external synchronization unit ESU-1 can be used with the
ARRIFLEX 435/435ES as well as with the ARRIFLEX 535,
535B and 16SR 3. It allows synchronization of the camera
to other equipment such as TV monitors. By means of a BNC-
socket, it is possible to synchronize to an external standard
video signal (50/60 Hz) or, through an inductive pickup, to
a computer or video monitor. The camera display shows
“ESU” in the upper line. The ESU-1 can be used for frame
rates from 3 to 60 fps.
Note: The ARRIFLEX 435/435ES can additionally be
synchronized within a frame rate range of 3 to
150 fps. An appropriate cable is available on
request.
The frame rate is indicated on the camera display in Mode 2.
A phase shifter and a pilottone generator have also been
integrated into the external synchronization unit. The synchro-
nization is retained even when the camera is switched off.
See TECHN. INFORMATION “External Synchronization
Unit ESU-1”.