ARRI ARRIFLEX 435 ES, Инструкция по эксплуатации

Страница: 65 / 143

65
Camera Operation
Selecting a Standard Frame Rate
(Mode 1)
Standby Operation
• The camera must be in Mode 1 and the “NORM/PS”
switch must be in the position “NORM”.
• Depress the “SEL”-button repeatedly until the desired
frame rate is selected. Within 3 seconds, confirm this
choice by depressing the “SET”-button, otherwise the
initial setting is retained.
Setting a Programmed Frame Rate
(Mode 2)
Standby Operation
• Change from Mode 1 to Mode 2 by depressing the
“MODE”-button once.
• Depress the “SEL”-button repeatedly until the digit to be
set blinks.
• Depress the “SET”-button repeatedly until the desired
value is reached.
• Repeat this procedure until all digits are set to the
desired values. For frame rates below 100 fps, a “0“
should be entered as the first digit, for frame rates above
100 fps, a “1“. A final confirmation of the set frame rate
is not necessary.
Note: The frame rate can be set between 1 and 150 fps.
For frame rates over 130 fps, a power supply
voltage greater than 24 V is necessary.
Note: An internal buffer battery ensures that the pro-
grammed frame rate is stored even if the camera
is not switched on at the main switch. This battery
has a lifetime of approx. 10 years. If the pro-
grammed frame rate is not available when the
camera is switched on again, the buffer battery
must be exchanged by an ARRI service center.