ARRI Arriflex 435 Advanced, Инструкция по эксплуатации, Страница: 95 / 156

95
The PROGRAM Menu
The PROGRAM menu enables writing and storing of programs
(ramps) to change the frame rate and shutter angle.
When the camera is set to HI or LO ramping speed, the
ramps that have been sent to the camera by the CCU
(LCC) are re-calculated to the fastest possible ramping
speed, and the total time of the ramp will be reduced as
much as possible (depending on magazine type and
supply voltage).
Check Mode 7 for the recalculated duration of the ramp.
Note: Minimum fps for internal ramps is 1 fps!
Up to 6 programs can be stored by the CCU-1. One at a
time can be transferred to the camera by depressing the
“SEND”-key. If the functional limits of the camera are
exceeded, the CCU-1 will show an error reading when
the selected values are sent to the camera.
General information:
• The “FETCH”-key transfers a program that is already stored
in the camera to the selected memory area of the CCU-1.
• The “DELETE”-key deletes the selected memory area.
• The “E” (edit)-key initiates the input of new values with
the keys.
Note: Frame rate programs (ramps) are defined by a
starting frame rate, an end frame rate and an
adjustment time.
In the same manner, the shutter angle can be
changed simultaneously within given limits.
Accessories
sliding switch “NORM – PS/CCU” “PROG”-button