D
1
Unpacking the kiosk
Attaching the baseplate
Set the kiosk on the floor
Removing the tablet carrier
2
Setup & assembly
B
C
D
Using two people
,
remove kiosk from box.
Remove base from
side panel. Remove
protective bag and
store for future use
Remove foam blocks
and store for future use.
Open the box
A
A Phillips head screwdriver is required for installation
1. Set the kiosk onto a sturdy work
surface - front down (
See yellow note
)
2. Set the baseplate along the
bottom of the kiosk as shown.
3. Secure three 1/4-20 x 1” screws
through the baseplate and into the
kiosk using the supplied Allen key
4. Ensure these screws are tight
!
To ensure the kiosk doesn’t get scratched:
leave the kiosk in the supplied plastic bag
and place a soft material on the work surface
such as cardboard, a blanket or towels
For ease of installation,
ensure the baseplate is
angled at 90˚ to the kiosk.
Tighten the three 1/4-20
x 1” long screws using
the supplied Allen key
This part is
easier with
two people
3
A
E
B
A
B
C
Turn tabs out
Remove ArmoLock
™
screws on both sides
Set the carrier
onto a work
surface
Turn the two tabs securing
the tablet carrier out so
they are vertical
Remove the top bar
and security screws
Hold onto the bar
so it doesn’t drop
Warranty & other
information available
at:
armodilo.com
90˚
Slide the tablet carrier out of the kiosk –
grabbing the two finger insets on either side,
slightly wiggle the carrier to get it started
Please retain packaging
material for future use.