Assembly Instructions
Aristotle
®
Casegoods
Aluminum Leg Table with Acrylic Panels
August 2012
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
1. Carefully place worksurface upside
down onto a soft, protective surface.
One at a time, position a leg assembly
over pre-drilled holes where it will be
installed. Some holes are pre-drilled in
the worksurface to aid in locating the
leg’s mounting position (Figure 1).
2. Secure the aluminum leg assembly to
the underside of the worksurface using
eight #8 x 1” wood screws provided.
Take care when tightening to not strip
screws in worksurface underside
(Figure 1).
3. If worksurface is 60” in length or
longer, a stiffener bar must be installed.
Align the four outside mounting holes of
the stiffener bar to the four, pre-drilled
mounting holes at the underside of the
worksurface and secure with four #8 x
1” wood screws. Use the remaining
mounting holes in the stiffener bar as a
template, and secure the bar to the
underside of the table top, using a total
of sixteen #8 x 1” screws (Figure 2).
Aristotle Casegoods
Aluminum Leg table with Acrylic Panels
Assembly Instructions
Figure 1
Figure 2
#8 x 1”
wood screw
#8 x 1”
wood screw
stiffener bar
aluminum
leg assembly
worksurface
worksurface
(60” or longer)
7HP37 - Hardware Pack
16
# 8 x 1”
Screws
Arist-Al Leg wt AcrPnls AI_3
1. Carefully place worksurface upside
down onto a soft, protective
surface. One at a time, position
a leg assembly over pre-drilled
holes where it will be installed.
Some holes are pre-drilled in the
worksurface to aid in locating the
leg’s mounting position (Figure 1).
2. Secure the aluminum leg assembly
to the underside of the worksurface
using eight #8 x 1” wood screws
as illustrated. Take care when
tightening to not strip screws in
worksurface underside (Figure 1).
3. If worksurface is 60” in length or
longer, a stiffener bar must be
installed. Align the four outside
mounting holes of the stiffener bar
to the four, pre-drilled mounting
holes at the underside of the
worksurface and secure with
#8 x 1” wood screws. Use the
remaining mounting holes in the
stiffener bar as a template, and
secure the bar to the underside
of the table top, using a total of
sixteen #8 x 1” screws (Figure 2).
