7
MAINTENANCE
B
G
N V
B
G
Read the section 'WARNING' first.
(For ELCB models only) (fig.7) (This procedure is highly recommended.)
Turn on the electricity and water supply, the Green ELCB lamp will light up. If
the Temperature Control Knob is in 'ON' position, the Red HEATER lamp will
light up also. Press the ELCB Test Knob, the ELCB and HEATER lamp should
go off. Press the Reset Knob to resume back the electricity supply.
If the ELCB or HEATER lamp does not go off when you press the ELCB Test
Knob, SWITCH OFF the mains supply and contact your sales agent for repair.
Special skill is required for repair. NEVER try to repair the unit by yourself.
Test the “ELCB”
regularly
Do not use thinner, alcohol, petrol or any other organic solutions to clean the
set, use only a damp cloth with mild detergent.
Cleaning
precaution
There are two filter located at the stop valve, one is Mesh Filter (installed at
the incoming water supply), another one is the built-in Filter as shown in
fig.8a.
Clean the Mesh Filter regularly to prevent blockage. Remove the built-in Filter
by turn it anti clockwise as shown in fig.8a. Take out the Filter and flush it with
water to remove any trapped sediments. (as shown in fig.8b)
Clean the filter
regularly
Turn and remove the Mist Column Ring with plier and then remove screw and
take out the Spray Ring for Cleaning purpose. Be careful when fixing back, it
must be tight fit, otherwise water will leak (fig.9a)
This innovative adjustable Handshower has 5 different spray actions ( STAN -
DARD, JUMBO , SOOTHE , MIX and MASSAGE ). The actions are described
as fig.9b.
Note : The specification, actual product's cosmetic design and accessories parts shown
are correct at the time of printing and may be subjected to change without prior notice.
Shower Accessories parts are optional for Multi-Point Models.
Shower head
cleaning
