Ariston 100 L, Руководство пользователя

Страница: 28 / 88

Heat pump water heater – GENERAL INFORMATION
26
2.5 Technical data table
Description Unit 80 L 100 L 110 L
Rated tank capacity l 80 100 110
Insulation thickness mm ≈41 ≈41 ≈41
Type of internal tank protection enamelling
Type of corrosion protection titanium impressed current anode + disposable magnesium anode
Maximum operating pressure MPa 0,8
Diameter of hydraulic connections II 1/2 M
Diameter of air exhaust/intake pipes mm 125-150
Minimum water hardness °F 12 (min 15 °F with softener)
Weight when empty kg 50 54 55
Heating element power W 1200 1200 1200
Protection rating IP24 IP24 IP24
Min. temperature of room of installation °C 1 1 1
Minimum volume of room of installation A m3 20 20 20
HEAT PUMP Unit
Heat rating
B
W 850
Average electrical power consumption B W 250
Max. electrical power consumption B W 350
Available static pressure Pa 65
Standard air flow rate m3/h 100÷200
Sound power dB(A) 45 (44 with Silent)
Level of sound pressure at 1 m dB(A) 36 (35 with Silent)
Max. pressure of refrigerating circuit (low-
pressure side)
MPa 1,2
Max. pressure of refrigerating circuit (high-
pressure side)
MPa 3,1
Minimum air temperature C °C -5
Maximum air temperature C °C 42
Quantity of R134a refrigerant fluid g 500
Amount of condensed water D l/h 0,15
PERFORMANCE Unit 80 L 100 L 110 L
COP E 2,6 2,6 2,6
COP B 3,4 3,4 3,4
Heating time with heat pump E h:min 5:30 7:25 8:20
Heating time with heat pump B h:min 4:15 5:50 6:30
Heating energy consumption B kWh 0,97 1,46 1,45
Max. amount of hot
water in a single intake
V40
F
Delivered at 55 °C l 93 127 136
Delivered at 62 °C l 113 155 169
Max. water temperature with heat pump °C 62 (55 factory setting) 62 (55 factory setting) 62 (55 factory setting)
Max. water temperature with heating element °C 75 (65 factory setting) 75 (65 factory setting) 75 (65 factory setting)
QPr (over 24h) kWh 0,46 0,5 0,5
Power source
Voltage / max. power consumption B V / W 220-240 single-phase / 1550
Frequency Hz 50
Max. current consumption A 6,3
(A) In the event of installation without ducting.
(B) Values obtained in compliance with EN255-3 norm with air temperature of 20 °C and relative humidity of 37%, input water temperature of 15 °C
and setting temperature of 55 °C.
(C) outside of the heat pump’s interval of operation, heating of the water is ensured by the heating element..
(D) Values obtained with air temperature 15 °C, 71% relative humidity; input water temperature 15 °C, setting temperature 55 °C.
(E) Values obtained in compliance with EN255-3 norm with air temperature of 7 °C and relative humidity of 87%, input water temperature of 15 °C
and setting temperature of 55 °C.
(F) Performance measured for input water temperature 15 °C.
Average value obtained on a significant number of products.