Web guide command register
Bit #
Value
Label
Description
0-7
NA
Reserved for future use
8
0/1
Remote control
0: if cleared to zero, the local operator interface have control over the web
guide
1: if set to one, the remote ethernet controller has control over the web guide.
The interface icons to control the web guide on the local operator interface
will be disabled. Information for monitoring purposes will be displayed on
the screen.
9
0/1
Manual/Auto
mode
0: if cleared to zero, the web guide will be placed in the manual mode
1: if set to one, the web guide will be placed in the automatic mode
10
0/1
Jog Left or
decrease
guidepoint
This bit performs two functions based on bit 9.
If bit 9 is cleared:
●
0: Stop Jog Left operation
●
1: Start Jog Left operation
Note that this register is a write only register and will not change state if the
web guide reaches the extreme position.
If bit 9 is set:
●
0: will clear the register and has no effect
●
1: will decrease the guide point by 0.254 mm or 1/100th of an inch
from the current value.
Note that this value on this register is momentary. Before decreasing the
guidepoint the bit needs to be cleared before setting it to one. Note that the
guide point cannot be at the extremes of the sensing window and will
automatically truncate if the extreme limit is reached. The extreme limit
depends on the sensor resolution and sensor width.
11
0/1
Jog Right or
increase
guidepoint
This bit performs two functions based on bit 9.
If bit 9 is cleared:
●
0: Stop Jog Right operation
●
1: Start Jog Right operation
Note that this register is a write only register and will not change state if the
web guide reaches the extreme position.
If bit 9 is set:
●
0: will clear the register and has no effect
●
1: will increase the guide point by 0.254 mm or 1/100th of an inch
from the current value.
Note that this value on this register is momentary. Before increasing the
guidepoint the bit needs to be cleared before setting it to one. Note that the
guide point cannot be at the extremes of the sensing window and will
automatically truncate if the extreme limit is reached. The extreme limit
depends on the sensor resolution and sensor width.
Content subject to change without notice
SCU5: Sensor and Web Guide Controller User Manual v 3.6| Page 58
Copyright © 2021 Roll-2-Roll Technologies LLC
+1-888-290-3215
