EN - 20
6. Clear grass from blower assembly.
7. Reinstall hose and tighten hose clamp.
OPERATING TIPS
IMPORTANT:
Do not remove more that 3.2
cm (1 1/4”) of grass when bagging.
• Cut grass when it is dry.
• Cut grass in two passes when cutting thick,
long, or wet grass. Make the first cut higher
than desired. Make the second cut at
desired height.
• Always use full throttle when bagging.
• Adjust ground speed as necessary to allow
the bagger to pick up clippings.
Your Ariens dealer can provide service and
adjustments to keep your unit operating at
peak efficiency.
Contact an authorized engine manufacturer’s
service center for engine service.
MAINTENANCE SCHEDULE
Replace V-Belt
1. Remove belt cover.
2. Release belt tensioner.
3. Remove belt from spindle pulley and
blower assembly.
4. Install new V-belt. See
5. Reinstall belt cover.
IMPORTANT:
NEVER spray unit with high-
pressure water. DO NOT store unit outdoors.
• Clean plastic surfaces with sponge and
mild detergent. Dry with a soft cloth.
• Remove all debris from hopper before
storing.
• Remove all dirt, grease, leaves, etc. from
unit.
• Store in a clean, dry area.
• Ensure all fasteners are properly tightened.
Inspect moving parts and belts for damage
and wear.
• Touch up all rusted or chipped painted
surfaces.
WARNING:
Blades rotate
when impeller rotates. Impeller
rotates when blades rotate.
Block blades to prevent
rotation before proceeding.
MAINTENANCE
WARNING:
AVOID INJURY.
Read and understand the
entire
Safety
section before
proceeding.
Service Performed
E
ach
Use
E
very10
h
rs.
Check Front Weight
•
Check Hose
•
Check Mesh Bags
•
Check Fasteners
•
Inspect Bagger Parts
•
Clean Unit
•
Check V-Belt
•
STORAGE
WARNING:
AVOID INJURY.
Read and understand the
entire
Safety
section before
proceeding.
