EN - 22
CHECK MOWER BLADES
Check blades for wear and damage. Replace
or sharpen as needed.
CHECK BATTERY
Clean Battery
1. Disconnect battery cables, negative cable
first.
2. Clean terminals and battery cable ends
with a wire brush.
3. Coat terminals with dielectric grease or
petroleum jelly.
4. Reinstall battery cables, positive first.
CHECK MOWER BELTS
Check belts for wear and replace as needed.
CHECK HYDRAULIC SYSTEM
Check Hydraulic Oil Level
1. Place unit in service position. See
2. Check oil level in expansion tanks. Oil
should reach the cold fill indicator mark.
See Figure
IMPORTANT:
Engine should be cold when
checking initial oil level.
3. Operate engine for 1 minute and recheck
oil levels.
4. Add hydraulic oil, if needed.
a. Remove expansion tank caps.
b. Fill expansion tanks with 15W-50
synthetic motor oil until oil reaches the
cold fill indicator mark. See Figure
c. Reinstall expansion tank caps.
Change Hydraulic Oil and Filter
1. Operate unit for a few minutes to warm
hydraulic oil.
2. Stop engine, remove key and wait for all
moving parts to stop and for hot parts to
cool.
3. Position container under oil filter to catch
used oil.
4. Remove filter guard and oil filter from
transaxle.
5. Remove the vent / fill plug from the fill
port and allow transaxle to drain
completely.
CAUTION:
AVOID INJURY. Use
sturdy gloves or padding to
protect hands when working with
mower blades.
Rotation of one blade rotates the
other blades.
CAUTION:
Unbalanced blades
cause excessive vibration and
eventual damage to unit.
Balance blades before
reinstalling on unit.
NEVER weld or straighten
blades.
WARNING:
Battery posts,
terminals and related
accessories contain lead. Wash
hands after handling.
CAUTION:
AVOID DAMAGE.
DO NOT allow tools to contact
metal surfaces when removing
positive battery cable.
CAUTION:
Keep body parts
away from idler when
releasing idler spring tension.
Figure
22
1. Cold Fill Line
