Page 2-32
0040506004 0919
Operating and installation instructions
Thrust actuator ARI-PACO
®
2G 1,6D/Y
5.5.4.2 Power supply
Fig. 15: Installtation and connection of the power supply ARI-PACO
®
2G
6.0 Putting the actuator into operation
6.1 Putting the actuator ARI-PACO
®
2G 1,6D into operation
When placing into service proceed as follows:
- Using the handwheel, run the thrust actuator to approximately mid lift position.
- Apply brief pulses to the thrust actuator for each direction of movement and check whether the
directions of movement correspond to those desired. If this is not the case, the pulse lines
governing the retracting and extending action must be exchanged on the thrust actuator.
- Run thrust actuator to the final position in each direction of movement and check whether it
switches off automatically and whether all externally moving parts are able to move freely.
- If failing to function properly, check all installation and setting work previously carried out,
correcting if necessary, and afterwards place into service once again.
ATTENTION !
All local safety instructions must be observed!
Before putting a new plant into operation or restarting a plant after repair or
modification, always make sure that:
- The power supply, control signal and ambient temperature coincide with the technical
data of the electronics.
- All work has been completed correctly!
The hood is mounted again following the completion of the adjustment work!
