OPENING THE SAFE USING THE OVERRIDE KEY
Use the Manual override key to open the safe.
Remove the plastic key lock cover (dia 1)
Insert the override key; turn it clockwise, at the same time
turn the locking knob clockwise and pull open the safe.
BATTERY REPLACEMENT
1. The digital safe uses four 'AA' type batteries (supplied).
• Remove the battery cover on the rear of the door (dia 5).
• Push the catch in and pull out the cover,
• Install the 4x 'AA' batteries supplied. Ensure correct polarity.
• Replace the battery cover.
• Keep the safe door open until you have set the PIN code.
The battery life is approximately one year.
Make a note of the battery replacement date.
However, we recommend checking the batteries every 6
months just to make sure
If batteries are removed from the safe the set PIN code
will be only remain in its memory for approximately 4 hrs
then it will need re-setting.
SECURING YOUR SAFE
ADVICE: We strongly recommend that you secure your safe to a wall
or floor using the wall bolts supplied.
Use the holes in the safe (Dia 6) to mark where you need to drill.
Loosely attach the wall bolts onto the safe with the nuts and washers
provided. Hold the safe over the drilled holes and locate the wall bolts
into these holes (Dia 6). Tighten the nuts from the inside of the safe to
secure firmly.
Please note that the wall bolts are only to be used in brick & cement structures.
Dia.5
Dia.6
Back of safe
Wall
Nut & Washer
on the inside of
the safe
Dia.4
