ARGENTO OMEGA, Руководство пользователя, Страница: 14 / 20

1 1 4 4
7. MAINTENANCE INSTRUCTIONS AND ROADING
All maintenance operations must be carried out with the battery removed and
the bicycle resting on the stand.
After each routine maintenance operation, a check on the perfect functioning of all
the controls is mandatory.
This manual does not include information regarding disassembly and extraordinary
maintenance, as these operations must always be carried out exclusively by the
service staff of your authorized ARGENTO dealer.
The Assistance Service is able to provide all the information and to answer all
requests to take care of and keep your pedal-assisted bicycle perfectly efficient.
Negative verification
• If even a single check is negative, DO NOT RIDE the pedal-assisted bicycle.
• Immediately take all measures to carry out a suitable repair and if
necessary, contact the service center of your dealer.
7.1 Cleaning
Cleaning the pedal-assisted bicycle is not only a matter of decorum but also allows
you to immediately detect any defect in the same.
In order not to damage or compromise the operation of the various components,
especially the electrical parts, cleaning must be carried out taking certain
precautions. It is absolutely forbidden to direct pressurized water jets towards the
electrical parts, the motor, the display and the battery, for which cleaning with a
sponge is recommended.
Before starting the pedal-assisted bicycle, dry completely with low-pressure
compressed air and check that there is no residual moisture on the electrical
components.
7.2 Chain lubrication
It is important to lubricate the chain regularly, to avoid excessive wear and to extend
its life.
Clean the entire length of the links with a rag.
Spray a specific grease in spray on the transmission chains on all the links.
7.3 Checking the parts
The supporting frame of the pedal-assisted bicycle and the welds must be free of
visible defects such as: cracks, deformations, incisions, corrosions, etc.
Make sure that all the bolts and pedals of the pedal-assisted bicycle are
properly tightened.
Check the condition and fastening of the battery, the sheaths of the electric cables
must be in good condition and the terminals must be tight and not corroded.
Check the battery charge status by means of the indicator on the handlebar display.
For a correct use of the battery of your EPAC vehicle it is suggested to
always charge the battery after each use of the bike.
Using the specific inflation valve on the rims, check the tire inflation pressure using
a compressor and a gun with pressure gauge.
Check the condition of the tread, the rim and the fastening of the rims to the hubs.
In case of tire replacement, contact the After-Sales Service or a qualified tire dealer.