Areca ARC-1330 Series, Руководство пользователя

Страница: 31 / 53

BIOS CONFIGURATION
31
The "Device Selection-Identify Disk" screen displays a scrolling
list of installed disks on the selected host adapter.
Highlight the disk name in the "Device Selection-Identify Disk"
screen and press Enter . The selected disk activity indicator will
light for physically locationg the selected disk. A screen similar
to the following appears:
Adapter#1- I/O=FD9FF000h, F2(Tab): Select Controller, F10: Reset System
ArrowKey Or AZ:Move Cursor, Enter: Select, ESC: Return To Previous Menu Item
Areca Technology Corporation SAS Controller
Main Menu
Miscellaneous Settings
System Information
Physical Devices
Device Function
Display Device Information
Low Level Format Disk
Verify Disk
Identify Disk Identify Disk
Device Selection - Identify Disk - 4 Device(s)
#01 SAS : P/I/L =1/01/000: 34(GB) : HUS151436VLS300
#02 SAS : P/I/L =2/02/000:137(GB) : ATLAS10K5_147SAS
#03 SAS : P/I/L =3/03/000: : 34(GB) : HUS151436VLS300
#00 SATA : P/I/L=0/00/000 : 76(GB) : ST6700630NS
Check Drive LED For Identification!
Press Any Key To Stop.
3.2.2 Miscellaneous Settings
To access the host adapter miscellaneous settings properties,
highlight the "Miscellaneous Settings" field on the main menu
screen and press Enter . A screen similar to the following appears:
Adapter#1- I/O=FD9FF000h, F2(Tab): Select Controller, F10: Reset System
ArrowKey Or AZ:Move Cursor, Enter: Select, ESC: Return To Previous Menu Item
Areca Technology Corporation SAS Controller
Main Menu
Physical Devices
Miscellaneous Settings
System Information
Miscellaneous Settings
Miscellaneous Settings
SATA NCQ Support
SMART Status Polling
Disk Write Cache
PCI Interrupt Type
PCIE Read Request Size
Max. Phy Link Rate
Max. Command Xfer Length
Delay Before Driver Load
INT 13 Service
Clear Persistent Mapping
Staggered Spin-up Config
Reset BIOS Parameters
SATA NCQ Support
Changes to the "Miscellaneous Settings" are reflected in the
option field of the "Miscellaneous Settings" menu. However, the
new setting does not take effect until you reboot the system.