Arctiko CRYO 170, Руководство по эксплуатации, Страница: 11 / 40

10
Before commissioning
1. Install the freezer on a flat and level floor.
The front side of the freezer should be approximately 1cm higher than the
backside
.
2. Clean the inside of the freezer and install the sub-lids.
3. Connect the freezer to the exclusive power outlet.
Do not use extension cords.
Do not use any electric outlet divider.
4. Before loading samples into the freezer, make sure the
inside temperature has reached the Set point.
The plastic odor will disappear once the freezer cools down.
Do not turn on the power for 30 minutes after moving, which may cause breakdown.
Warning
Do not put bagged ice packs (including those containing
ammonium nitrate and urea) in the freezer. Leakages from such
bags may cause rust or breakdown of the freezer.
Do not place any form of volatile substance or inflammable, such
as ether, benzene, alcohol, propane gas and glue, etc. inside the
Freezer. Failure to follow these instructions may lead to
explosions or fire.
Any type of bottles or cans containing liquid fluids with
hermetic sealed lids, can break course to higher pressure,
should never be stored in the freezer since the bottles and cans
may explode. This could lead to personal injury.
Do not touch stored materials, containers (especially metallic ones),
or the inside of the freezer with bare or wet hands. Failure to
follow these instructions may lead to frostbite. Make sure to wear
gloves when working.