Arctic Cat S2009BCDFCOSL, Руководство оператора

Страница: 48 / 88

44 MAINTENANCE

NOTE: If the warning icon does
not illuminate, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for service. If
not under warranty, this service is
at the discretion and expense of
the snowmobile owner.
13. If the warning icon illuminates
(from step 12), start the engine.
The warning icon should go out
within five seconds. If it does, pro-
ceed to step 14.

NOTE: If the warning icon does
not go out, shut the engine off
immediately and repeat step 11;
then place the ignition switch to the
ON position and repeat step 13. If
the warning icon does not go out,
take the snowmobile to an autho-
rized Arctic Cat Snowmobile dealer
for service. If not under warranty,
this service is at the discretion and
expense of the snowmobile owner.
14. Shut the engine off and pour the
remaining amount (0.9 l or 1 U.S.
qt) of recommended oil into the oil
reservoir; then proceed to the
Checking Engine Oil Level (1100
cc Models) sub-section to verify
and finalize the procedure.
COOLANT LEVEL

NOTE: Use a good quality, ethyl-
ene glycol-based, automotive-type
antifreeze.
500/600/800/1000 cc

NOTE: Always check the coolant
level with the engine cold.
Locate the appropriate FULL mark on
the coolant reservoir. If coolant is
below the FULL mark, add antifreeze
to the FULL mark.
On the F-Series/T-Series if adding
coolant, the console must be removed.
For Removing/Installing the console,
use the following procedure.
1. Remove the two torx-head screws
securing the console to the chassis;
then lift up the rearward end of the
console and disconnect the console
harness plug-in.
0743-428
2. Remove the console.
3. Place the console into position on
the headlight support bracket; then
connect the console harness con-
nector.
4. Secure the console to the chassis
with the two torx-head screws.
1100 cc

NOTE: Always check the coolant
level with the engine cold.

NOTE: The hood must be
removed for this procedure.
Locate the FULL COLD mark on the
coolant reservoir (located in the for-
ward engine compartment below the
hood hinge bracket).
If the coolant is below the FULL
COLD mark, add antifreeze to the
FULL COLD mark.
! CAUTION
After operating the snowmobile for
the initial 5-10 minutes, stop the
engine, allow the engine to cool
down, and check the coolant level.
Add coolant as necessary.