Arctic Cat HDX 500 2017, Руководство по обслуживанию

Страница: 13 / 190

12
Headlight - Taillight/
Brakelight
HEADLIGHT
 NOTE: The bulb portion of the headlight is fragile.
HANDLE WITH CARE. When replacing the head-
light bulb, do not touch the glass portion of the bulb.
If the glass is touched, it must be cleaned with a dry
cloth before installing. Skin oil residue on the bulb
will shorten the life of the bulb.
To replace the headlight bulb, use the following procedure.
1. Remove the wiring harness connector from the back
of the headlight.
2. Grasp the bulb socket, turn it counterclockwise, and
remove. Discard the bulb.
XR065C
3. Install the new bulb into the socket and rotate it com-
pletely clockwise in the housing.
4. Install the wiring harness connector.
TAILLIGHT-BRAKELIGHT
To replace the taillight-brakelight bulb, use the following
procedure.
1. Remove the two cap screws and lock nuts and
remove the light assembly.
2. Rotate the bulb socket counterclockwise to remove it
from the light assembly; then pull straight out on the
bulb. Push the new bulb straight into the socket.
3. Install the bulb and socket into the light assembly
and turn clockwise to lock in place.
4. Install the taillight-brakelight assembly on the can-
opy support.
CHECKING/ADJUSTING HEADLIGHT
AIM
The headlights can be adjusted vertically. The geometric
center of the HIGH beam light zone is to be used for aim-
ing.
1. Position the vehicle on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming surface).
0748-733

NOTE: There should be an average operating load
on the vehicle when adjusting the headlight aim.
2. Measure the distance from the floor to the mid-point
of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the most intense beam is centered on the verti-
cal mark 5 cm (2 in.) below the horizontal mark on
the aiming surface.
7. Loosen the headlight adjustment screw; then adjust
the headlight up or down as required. Tighten the
headlight adjustment screw.
PR875A
Shift Cable
CHECKING SHIFT CABLE
Turn the ignition switch on; then shift the transmission
into park. The letter P should illuminate on the LCD
gauge and the park icon (P) should illuminate. The vehi-
cle should not be able to move.
! WARNING
Do not attempt to remove the bulb when it is hot. Severe
burns may result.