41
General Information
Control Locations and
Functions
Ignition Switch Key
Two keys come with the ATV. Keep the
spare key in a safe place. An identifying
number is stamped on each key. Use this
number when ordering a replacement key.
ATV-0055C
Ignition Switch
The ignition switch has three positions.
ATV-0056
OFF
position — All electrical circuits
except the accessory plug are off. The
engine will not start. The key can be
removed in this position.
NOTE: The accessory plug is pow-
ered by the battery at all times.
ON
position — The ignition circuit is
complete and the engine can run. The key
cannot be removed in this position.
LIGHTS
position — The ignition circuit
is complete and front (if equipped) and
rear running lights are on. The left con-
trol switch can be moved to illuminate
the high beams and low beams. The key
cannot be removed in this position.
Shift Lever
XR004A
This ATV has a dual-range automatic
transmission with reverse and park.
Drive Select Switch
XR068B
This switch allows the operator to oper-
ate the ATV in either two-wheel drive
(rear wheels) or four-wheel drive (all
wheels). For normal riding on flat, dry,
hard surfaces, two-wheel drive should be
sufficient. In situations of aggressive trail
conditions, four-wheel drive would be
the desired choice.
CAUTION
Leaving the ignition switch in the ON
or LIGHTS position for a long period
of time when the engine is not run-
ning may cause the battery to dis-
charge. Always leave the ignition
switch in the OFF position when
engine is not running.
