3-32
NOTE: Always use a new snap ring when install-
ing the oil pump driven gear.
17. Remove oil pump driven gear. Account for the
drive pin and thrust washer.
MD1020
G. Oil Pump/Oil Strainer
NOTE: Steps 1-17 in the preceding sub-sections
must precede this procedure.
18. Remove three cap screws holding the oil pump
and remove the oil pump. Account for two align-
ment pins.
MD1060
19. Remove the four cap screws securing the oil
strainer cap; then remove the Phillips-head screws
securing the oil strainer. Account for the O-ring.
MD1207
Servicing Right-Side
Components
NOTE: Whenever a part is worn excessively,
cracked, damaged in any way, or out of tolerance,
replacement is necessary.
INSPECTING CENTRIFUGAL
CLUTCH SHOE
1. Inspect the clutch shoe for uneven wear, chips,
cracks, or discoloration.
2. Inspect the depth of the grooves in the clutch
shoes. If any shoe is worn to the bottom of the
groove, replace the complete set.
AT THIS POINT
To service clutch components, see Servicing
Right-Side Components sub-section.
AT THIS POINT
To service center crankcase components only, pro-
ceed to Separating Crankcase Halves.
CAUTION
Always replace clutch shoes as a complete set or
severe imbalance could occur.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
