Arctic Cat 450 2010, Руководство по обслуживанию

Страница: 111 / 149

6-13
6
CF266A
CF267A
10. Apply a liberal amount of grease to the O-ring;
then install it on the assembled cover assembly
making sure to seat the O-ring down around the
circumference of the bearing flange.
11. Making sure the O-ring is properly positioned on
the differential/gear case cover assembly, install
the cover with existing hardware. Account for the
ID tag. Tighten the cap screws (coated with green
Loctite #609) to 23 ft-lb.

NOTE: Grease can be applied to the O-ring for
ease of assembling.

NOTE: If a new gear case housing is being
installed, tighten the cap screws to 25-31 ft-lb.
Removing Needle Bearing

NOTE: Removing the needle bearing is rarely
necessary. Avoid removing the needle bearing
unless the bearing is clearly damaged.

NOTE: This procedure can be performed on a
rear gear case.
1. Place a 1/4 in. drill bit on the inside surface of the
needle bearing (against the bottom side); then drill
through the pinion shaft needle bearing housing.
CC885
2. Using a propane torch, heat the area surrounding
the needle bearing to soften the Loctite.
CC886
3. Using a flat-nosed punch, drive the bearing out of
the housing.
CC887
Installing Needle Bearing
1. Apply red Loctite #271 to the outside of a new
bearing; then place the new bearing into the hous-
ing.
Next Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com