Driving 6
49
6.10
Removing and attaching
passenger seat (only for
TRV)
Removing passenger seat:
1. Pull both handles (1) backwards.
2. Position both handles (1) vertically.
3. Lift rear end of the seat.
4. Pull seat slightly backwards and lift out
of the holding frame.
Attaching the passenger seat:
1. Insert both holding brackets of the
passenger seat into the holding frame.
2. Press front part of the passenger seat
downwards.
Fig. 33
3. Push passenger seat forwards until the rear flaps of the passenger seat engage
at the rear of the holding frame.
4. Position both handles (1) horizontally.
5. Push both handles (1) forwards as far as they will go.
6.11
Filling up
1. Switch vehicle off.
2. Open fuel cap.
3. Fill in fuel of the quality specified below, maximally up to the lower edge of the
filler neck.
Recommended fuel: Unleaded petrol, 95 octane.
NOTE
The rack and the cargo box are removed and attached in the same way.
WARNING
Fuel is highly flammable. Fire at the fuel tank may lead to fire and explosion.
Do not fill up the vehicle in the vicinity of naked flames or burning cigarettes,
and always stop the engine when filling up.
Ensure that no fuel is spilled, particularly on hot parts of the vehicle. Wipe
spilt fuel up immediately.
Fuel expands when subjected to heat. In the case of a fuel tank which is too
full, fuel may escape. Observe the specifications on the fuel tank.
