Controls 4
31
High beam indicator
(9) – the high beam indicator appears when the high beam is
switched on.
Drive indicator
(10) – Displays "4WD" when this drive has been selected with the
drive selector switch. The 2WD mode will not be displayed.
Speedometer
(11) – Displays the approximate speed of the vehicle in kilometres per
hour (km/h) or in miles per hour (MPH).
Toggling between "km/h" and "MPH" display:
1. Press "M" button (3) to select the "Speedometer/gauge" mode. The (MPH/km/h)
icon appears.
2. Press "S" button (4) to change the display.
Status warning indicator
– Any system error which must be rectified will be dis-
played in the odometer display of the gauge display. The following error displays are
possible:
– VOLT
In the event of a voltage drop (< 9 V) or an overvoltage (> 16 V), the gauge display
only displays the flashing word "VOLT". When the voltage returns to the normal
value, the display must be reset manually. To do this, turn ignition key to OFF posi-
tion and, thereafter, to the ON position again.
– EFI
Electronically controlled Fuel Injection. If an error occurs in the injection system,
the entire gauge display of the cockpit goes out for 30 seconds. During this time,
only the flashing error display (DTC) and graphic display of a wrench are dis-
played. After 30 seconds, the gauge displays appear in addition to the error dis-
play. After rectifying the displayed error, the error display will automatically go out.
NOTE
If a gear position is not recognized, an "E" will appear in the indicator.
NOTE
The park position "P" is not displayed in the cockpit in the case of all vehi-
cles.
NOTE
In the case of vehicles with differential lock, the text "Lock" will be displayed
underneath the "4WD" icon when activating the front axle differential lock.
NOTE
Have an EFI error rectified as soon as possible at an authorised Arctic Cat
specialist repair shop.
