4 Controls
24
4.9
Parking brake
By pulling the parking brake lever (2) in the 2WD function, the brakes of the rear axle
are actuated mechanically. After the brake lever lock (3) has engaged, the wheels are
permanently locked.
Activating the parking brake:
1. Pull parking brake lever (2) towards the handlebar
2. Push brake lever lock (3) to the side until it engages in the pin (1).
3. Release parking brake lever (2).
4. Check if the brake lever lock (3) has engaged correctly and the brake locks the
wheels.
Releasing the parking brake:
1. Pull parking brake lever.
2. The parking brake lever returns to its
starting position.
Fig. 15
WARNING
Do not use parking brake as main brake.
NOTE
Models equipped with a "P" position, do not have any parking brake but a
hydraulic emergency brake.
If the main brake has failed, the brake on the right-hand side of the handlebar
may be used as an emergency brake.
NOTE
When the brake lever lock (3) engages, a clicking noise is heard. The park-
ing brake lever (2) does not return to its starting position after releasing. The
wheels shall be locked. If this is not the case, have the vehicle serviced at
an authorised Arctic Cat specialist repair shop.
WARNING
Before driving, check if the park-
ing brake is released.
