4 Controls
20
4.3
Battery cut off switch
With the battery cut off switch (1), all elec-
trical circuits of the vehicle can be discon-
nected from the battery. Then, the electri-
cal circuits cannot be switched on again
via the ignition switch.
The battery cut off switch (1) is located
underneath the seat.
Fig. 10
4.4
Operator presence control (OPC)
After 10 seconds, the operator presence control (OPC) activates an alarm signal and
"OPC" appears on the gauge display when the following conditions are fulfilled:
●
Ignition is switched on or the engine is running.
●
Gear lever is in any gear position except P (park position).
●
Thumb throttle is not actuated.
●
No service brake is actuated.
NOTICE
Only applies to vehicles with T3b
approval.
NOTICE
Only applies to vehicles with T3b approval.
NOTICE
When actuating the brake and/or the thumb throttle, or when moving the
gear lever to position P (park position), the alarm signal and the text in the
gauge display go out.
