3-24
CC003D
30. In a crisscross pattern starting from the center and
working outward, tighten the cap screws (from step
29) to 8.5 ft-lb.
31. Adjust valve/tappet clearance (see Section 2).
32. Place the two tappet covers into position making sure
the proper cap screws are with the proper cover.
Tighten the cap screws securely.
CC001D
33. If removed, install the spark plug. Tighten securely.
Left-Side Components
NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Left-Side
Components
A. Outer Magneto Cover
B. Water Pump
C. Cover
D. Rotor/Flywheel
1. Remove the four cap screws securing the outer mag-
neto cover to the left-side cover; then remove the
outer magneto cover. Account for the gasket.
2. Remove the flange nut securing the bushing to the
crankshaft; then remove the bushing. Account for the
O-ring inside the spacer.
3. Using a cold chisel, scribe a mark showing the rela-
tive position of the shift arm to the shift arm shaft to
aid in installing; then remove the shift arm.
FI085A
4. Remove the cap screws securing the speed sensor
housing to the crankcase and remove the housing
assembly; then remove the snap ring securing the
speed sensor trigger to the shaft and remove the trig-
ger. Account for the gasket.
NOTE: It may be necessary to use a small two-jaw
puller to remove the trigger.
CD920
AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
