Archgard OPTIMA 30 - 1, Руководство пользователя по установке, эксплуатации и техническому обслуживанию, Страница: 15 / 32

O
PTIMA 30-1 15
WARNING: THE OPTIONAL BAY DOOR IS A DECORATIVE OPTION ONLY AND IS
MANUFACTURED WITH TEMPERED GLASS. THIS UNIT MUST NOT BE OPERATED
WITHOUT THE FLAT CERAMIC GLASS DOOR SECURED IN PLACE, BEHIND IT.
NOTE:
Ensure the fireplace is turned off and cool, disconnect the power to the unit.
1 Remove the upper grilles by pulling the assembly forward.
2 Remove the lower grilles by removing the four hex head mounting screws.
3 Remove the two hex head screws from the existing Control Panel Bracket, and pull the
assembly out from under the firebox.
4 Remove the Fan Control Knob, remove the mounting nut, push the rheostat back out
of the hole, and disconnect the quick connect plugs from the wire and the thermal
switch on the underside of the firebox.
5 Plug the included 10” black extension wires onto the rheostat wires, the power wire,
and the spade connector of the thermal switch on the underside of the firebox. (Fig. 1)
6 Remove the sparker wire from the existing piezo sparker.
7 Place the rheostat through the corresponding hole in the Bay Control Panel Bracket so
that the wires extend to the left, tighten the nut, and push the knob back on.
8 Install the 6” Hi/Low and 6” On/Off extension knobs onto the corresponding knobs on
the valve.
9 Place the Bay Control Panel Bracket over the extension knobs, move the rear bend
over the bottom bend of the heater, and insert the left side in front of the Fan Control
Bracket.
10 Line up the corresponding mounting holes, see Fig. 2, and turn the two new hex head
screws in.
11 Push the sparker wire onto the new piezo on the Knob Extension Kit Bracket.
12 Move the Bay Assembly over the front of the insert, line up the slots in the upper area
slightly above the corresponding tabs at the front top of the firebox, and push the
assembly down.
Fig. 2.
Fig. 1.
INSTALLATION INSTRUCTIONS
Cont...
OPTIONAL BAY DOOR INSTALLATION
f i r e - p a r t s . c o m