Archgard OPTIMA 30 - 1, Руководство пользователя по установке, эксплуатации и техническому обслуживанию, Страница: 10 / 32

O
PTIMA 30-1 10
INSTALLATION INSTRUCTIONS
Cont...
ELECTRICAL CONNECTIONS
The Optima 30 comes complete with an electrical cord and plug already installed. If you
require to run an electrical lead to the appliance instead, follow the instructions listed below.
Have qualified electrician run a set of 120VAC supply lines to the lower left side of the fireplace
before installing the appliance. He should leave 18” (460mm) of the supply line free for ease of
connection to the appliance. Connect the electrical supply line to the appliance at the same
time the gas line is being connected to the appliance.
Flip open the bottom grill and undo the 2 screws holding the control panel. Run the lines into
the left side of the appliance through the conductor clamp. Run the lines through the conductor
clamp on the controller box. Connect the ‘live’ (black) supply conductor to the free black
conductor from the speed controller with a marrette type wire connector. Connect the ‘neutral’
white supply conductor to the free white conductor from the convection fan with a marrette type
wire connector. Connect the ‘ground’ (green or bare) conductor to the ground screw formerly
used by the cord and plug. Replace the control panel and fasten with the 2 screws.
MOT
SPEED
CONTROL
110F (43ºC) N.O. THERMAL
SNAP SWITCH
CONVECTION BLOWER
LINE
GROUND
NEUTRAL
SIDE OF GAS
FIREPLACE
120 VAC
white
black
SPEED CONTROL
LINE
GROUND
NEUTRAL
110F (43ºC) N.O. THERMAL
SNAP SWITCH
CONVECTION BLOWER
Before connecting the appliance to the gas supply line, double check that the appliance you
have purchased is design for the gas type you are using. The gas type markings are located
on the certification label and also on the appliance’s gas valve.
Adequate clearance for proper installation and checking of the gas connections must be
provided. All gas connections must be checked for gas leaks.
f i r e - p a r t s . c o m