Archgard Optima 20-1, Руководство по установке, эксплуатации и обслуживанию для пользователей, Страница: 27 / 33

O
PTIMA 20 - 1 27
•
Remove the gas component assembly.
•
Mark all wires to be removed for proper reassembly
CAUTION: Wiring errors cause improper and dangerous operation.
•
The convection blower is located at the bottom of the appliance at the back. Remove the
three screws holding the blower.
•
Lift the blower out and disconnect the wires from the blower.
REPLACING CONVECTION BLOWER
IF YOUR GLASS BREAKS...
In the event your glass cracks or breaks, it must be replaced by the exact same size and mate-
rial. It is made from high temperature ceramic material. See replacement parts list and contact
your nearest Archgard dealer.
•
Remove door and carefully remove all traces of glass and gasket material.
•
Replacement requires Ceramic glass part #307-0041, gasket part #314-0000 and sealer part
#319-0005.
•
Install new glass with new gasketing in place. The “thicker” side of the gasket fits against the
fireplace opening.
•
Hold glass in place by using the sealer between gasket and door. Use sparingly so that no
excess will be visible. DO NOT PUT ANY SEALER BETWEEN GLASS AND UNIT OPENING.
•
Replace the door carefully making sure all three clamps are closed.
SERVICING
Cont...
CHECKING PILOT ORIFICE
Pilot burner head
Retaining clip
The pilot orifice sits underneath the pilot burner head.
Remove the head just by pulling it off. You may have
to wiggle it a bit. DO NOT REMOVE THE RETAIIN-
ING CLIP. Use a 5/32 Allen wrench to remove the ori-
fice. Replace in reverse order. There is a notch in the
head to line it up correctly on replacement. Ensure the
head is pushed down all the way.
Call your local Authorized Archgard Dealer to pur-
chase the correct fuel conversion kit for your gas
appliance.
f i r e - p a r t s . c o m