Archgard Optima 20-1, Руководство по установке, эксплуатации и обслуживанию для пользователей, Страница: 19 / 33

O
PTIMA 20 - 1 19
OPERATION INSTRUCTIONS
FOR YOUR SAFETY, READ BEFORE LIGHTING
This appliance has a pilot which must be ignited using the sparker located next to
the appliance valve controls. When lighting the pilot, follow the start-up procedures
exactly.
Do not use this appliance if any part has been under water. Immediately call a
qualified service technician to inspect the appliance and to replace any part of the
control system and any gas control which has been under water.
Use only your hand to push in or turn the gas control knob. Never use tools. If the
knob will not push in or turn by hand, do not try to repair it. Call a qualified service
technician. Force or attempted repair may result in a fire or explosion.
BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell
next to the floor, because some gases are heavier than air and will settle on the
floor.
IF YOU SMELL GAS, follow the instruction on the front cover of this manual.
A.
B.
C.
D.
INITIAL OPERATION
•
Check that the appliance is properly vented and connected to the gas supply
•
Check that the logs and branches are properly placed
•
Check that all external parts, such as grills, door and faceplate are properly attached and
fastened
•
Check that there are no finger prints left on gold surfaces as high temperature can bake
these prints permanently
NOTE: When operated for the first few times, the appliance will emit some odor and fumes.
This is due to the heat from the appliance evaporating the oils and solvents used in
fabricating the appliance. Close off the room to the rest of the house and open all
windows. Keep the room well ventilated as smoke alarm may sound. Run the
appliance for at least 4 hours at maximum setting with blower set to “OFF” to allow
paint to cure. If smoke alarms are disconnected during this curing time, remember to
reconnect them later.
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
Do not operate the appliance with the glass front removed, cracked
or broken. Replacement of the glass should be done by a licensed
or qualified service person
.
E.
This appliance is equipped with a three-prong (grounding) plug for your protection
against shock hazard and should be plugged in directly into a properly grounded
three-prong receptacle. Do not cut or remove the grounding prong from this plug.
f i r e - p a r t s . c o m