Archgard 72-DVTE30N-2, Инструкция по установке, эксплуатации и обслуживанию, Страница: 46 / 60

72-DVTE30-2
46
REMOTE CONTROL SETUP AND OPERATION, cont.
Continuous Pilot on Demand / Intermittent Pilot (CPI/IPI) Selection
With the system in “ OFF ” position press the Mode Key to index to the CPI mode icon.
Pressing the UP Arrow Key will activate the Continuous Pilot on Demand Ignition mode (CPI). Pressing the Down Ar-
row Key will return to IPI. A single “ beep ” will confirm the reception of the command.
CPI vs IPI:
Continuous Pilot on Demand Ignition (CPI) : In this mode the pilot runs continuously even when the main
burner is off. The Continuous Pilot on Demand Ignition operates on a seven day cycle. If the main burner is
not turned on for seven continuous days, the pilot will turn itself off. When the main burner is lit again the
cycle repeats. The pilot will remain lit for seven days, even after the main burner is turned off. If the main
burner is lit during a seven day timing cycle, the seven day timer will reset.
Intermittent Pilot Ignition (IPI) : A fuel saving mode in which the pilot is only used when the main burner is
on. This appliance is shipped in IPI mode. IPI mode is often the preferred method, however, there are some
situations where it may be preferable to switch the fireplace into CPI mode. For example, in colder climates
the glass door or the front of the fireplace could become very cold to the touch. Dynamic Start Advantage will
solve most problems experienced by older IPI operated fireplaces.