Archgard 72-DVTE30N-2, Инструкция по установке, эксплуатации и обслуживанию, Страница: 25 / 60

72-DVTE30-2
25
ELECTRICAL CONNECTIONS, FAN SYSTEM
WARNING: Before starting, make certain the power supply is turned OFF.
Have a qualified electrician run a 120VAC supply line to the lower left side of the fireplace
before installing the appliance. There should be 18” (460 mm) of the supply line free for ease of
connection to the appliance. Connect the electrical supply line to the appliance at the same
time the gas line is being connected to the appliance.
NOTE: This appliance, when installed, must be electrically grounded in accordance with local
codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 , or
the Canadian Electrical code, CSA C22.1.
Open the bottom (louver) grill and undo the 2 screws holding the control panel. Run the line into
the left side of the appliance through the hole in the rear of the junction box and hold with a
standard 7/8” (22 mm) clamp. Connect the (black) supply conductor to the free black conductor
from the speed controller with a marrette type wire connector. Connect the ‘ neutral ’ white
supply conductor to the free white conductor from the fan with a marrette - type wire connector.
Connect the ‘ ground ’ ( green or bare) conductor to the ground screw in the junction box.
Replace the junction box cover the control panel and fasten with the 2 screws. A BX connector
or other suitable approved wiring strain relief must be installed on the junction box.
The fan may be operated by the remote control or by having a qualified electrician wire the
fireplace to a thermostat. In thermostat mode the fan will start approximately 5 minutes after the
fireplace is turned on and stop approximately 12 minutes after the burner shuts off.
WIRING DIAGRAM