Archgard 45-DVFE28LN-1, Инструкция по установке, эксплуатации и обслуживанию, Страница: 10 / 68

10
Installation
6.3 Glass Door Installation
WARNING: Do not operate appliance with the glass front removed, cracked, or broken. Replacement of the glass should be done by
a licensed or qualified service person. Do not attempt to remove the glass door when the appliance is hot. Be sure there
are no fingerprints left on the glass panels during install or when cleaning as high temperatures can bake these prints on
permanently. Inspect the door gasket to ensure no damage has occurred when installing the glass door.
Figure 6.3.01: Figure 6.3.02:
Step 1: Open the side doors. Step 2: Unlatch the J-hooks on the right side of the door.
Step 3: Swing the door open. To remove the door:
If the door must be removed, lift the door to remove the lower
part of the hinge. Then lower the door to clear the upper part of
the hinge. Installation is the reverse of removal.
Figure 6.3.03:
Figure 6.4.04:
If Your Glass Breaks
In the event your glass cracks or breaks, replace the original
door assembly with Archgard replacement door assembly (part
number RP-845-0000). The glass door and frame assembly must
be replaced as a complete unit. Remove the barrier screen (See
Section 6.3 ) and remove door as per the instructions above.
Replace with new door assembly and reinstall the barrier screen.
NOTE:
the NEW door will emit some odor when the appliance
is lit. The odor will dissipate after the gasket material within the
door has cured. Be sure there are no fingerprints left on the
glass panels as high temperatures can bake these prints on
permanently.
Warning: Only doors certified with the appliance shall be used.
Do not use substitute glazing materials.
Note:
For most tasks, it is not necessary to remove the door. Simply
opening the door is sufficient to access the firebox.