43
Installation
Step 1:
Logs use pre-drilled holes and pins in the burner to ensure
proper alignment. Beginning with Log 1, locate the holes in the
bottom of the log.
Step 2:
Lower Log 1 onto the pins in the log rest at the back of the
firebox.
Figure 16.1.03:
Figure 16.1.04:
Figure 16.1.06:
Step 4:
Place Log 2 in the front left corner as shown using the two
front pins on the left side.
Step 3:
Spread some embers along the back side of the burner.
DO NOT
block the gap around the burner as this supplies
secondary air to the fireplace.
DO NOT BLOCK
Figure 16.1.05:
Step 5:
Gently lift Log 1 in order to place Log 3 on two pins.
Figure 16.1.07:
Step 6:
Place Log 4 on pin between Log 1 and Log 2. Log 1 has a
key detail that locks into the back of Log 4.
Figure 16.1.08:
1
1
2
3
4
The cutout in the log
aligns with the pilot
16.1 Grand Timber Log Set Installation