11
Installation
6.5 Accessing The Controls
Figure 6.5.01:
Figure 6.5.02:
To access the control board or valve:
1.
Remove the barrier screen (See
Section 6.3
).
2.
Slide the access doors back as shown in
Figure 6.5.01
.
3.
Remove the wire cover by rotating the front of the cover up and out. Lifting the cover from the retainer magnets at an angle. See
Figure 6.5.02
and
Figure 6.5.03
.
4.
Slide the valve or control board out. See
Figure 6.5.04
.
Use two hands when moving the access doors, valve slider, or control board slider.
Ensure wires or gas lines are not pinched, kinked, or over-extended when moving the valve or control board.
Figure 6.5.03:
Figure 6.5.04:
Left Side
Right Side
Left Side
Right Side
Note:
When reinstalling the wire cover be sure the wires are not touching the magnets on the left and right side of the fireplace.