10
Installation
6.4 Glass Door Installation
WARNING:
Do not operate appliance with the glass front removed, cracked, or broken. Replacement of the glass should be done by
a licensed or qualified service person. Do not attempt to remove the glass door when the appliance is hot. Be sure there
are no fingerprints left on the glass panels during install or when cleaning as high temperatures can bake these prints on
permanently. Inspect the door gasket to ensure no damage has occurred when installing the glass door.
Figure 6.4.01:
Figure 6.4.02:
Step 1:
Hook the bottom of the door in the lower spring assembly
on the firebox. Rotate the door up.
Step 2:
Ensure the bolt on the upper door spring is centered on
the door latch on both sides.
Step 3:
Lift the door spring up and over the door latch. The door
latch will pass through the cut-outs on the door buckle.
Step 4:
Make sure the upper springs are fully engaged with the
door latches.
Figure 6.4.03:
Figure 6.4.04:
If Your Glass Breaks
In the event your glass cracks or breaks, replace the original
door assembly with Archgard replacement door assembly (part
number
RP-841-0000
). The glass door and frame assembly must
be replaced as a complete unit. Remove the barrier screen (See
Section 6.3
) and remove door as per the instructions above.
Replace with new door assembly and reinstall the barrier screen.
NOTE:
the NEW door will emit some odor when the appliance
is lit. The odor will dissipate after the gasket material within the
door has cured. Be sure there are no fingerprints left on the
glass panels as high temperatures can bake these prints on
permanently.
Warning:
Only doors certified with the appliance shall be used.
Do not use substitute glazing materials.
Pass door latch
through cut-outs on
door buckle.
Back side view