Archgard 40-dvi40n Optima 40 - SB, Инструкция по установке, эксплуатации и обслуживанию, Страница: 27 / 45

Optima 40 - SB
27
OPTIONAL BAY DOOR INSTALLATION
CAUTION:
Only trim kit (s) supplied by the manufacturer may be used in the installation of this appliance.
After opening the bay door package, inspect the door to ensure that no damage has occurred
inside the package. Please report any damage immediately to your Authorized Archgard Dealer.
Installation of the Bay Door Option does not change any clearances stated on the rating
plate or Installation Operation and Maintenance Manual accompanying the appliance.
NOTE: Ensure that the Heater is turned off and cool.
To install this Bay Door Accessory use the following instructions:
1. Remove the upper grilles by pulling the assembly forward.
2. Remove the lower grilles by removing the four hex head mounting screws that secure the
brass hinges to the unit.
3. Discard the upper and lower grilles (they are not required for Bay door installation).
4. Move the Bay Door over the front of the insert, line up the slots in the upper area slightly
above the corresponding tabs at the front top of the firebox, and push the assembly down.
Align the hi/lo and on/off knobs (supplied) over the existing knobs by lining up the notches.
5. The lower louver (center) hinges down for control access.
WARNING: THE OPTIONAL BAY DOOR (40-DBAY) IS A DECORATIVE OPTION ONLY AND
IS MANUFACTURED WITH TEMPERED GLASS. THIS UNIT MUST NOT BE OPERATED
WITHOUT THE FLAT CERAMIC GLASS DOOR SECURED IN PLACE, BEHIND IT.