Archgard 36-DVIE40LN-1, Инструкция по установке, эксплуатации и обслуживанию, Страница: 43 / 68

43
Operation
Initializing the System for Handheld / Wall Mount Remote Operation
1. Connect IFC Control Module to AC power supply. A single “beep” will indicate the presence of power. NOTE: This will initiate Pilot
Start-up in Manual Mode. The pilot will spark repeatedly and ignite if gas has been supplied to the unit . Sync the control
board to the remote to turn main burner and pilot off using the steps below.
2. The ON/OFF Override Jumper on the control board must be connected.
3. Press and hold th red SW1 button until the IFC module beeps three (3) times and/or the amber LED illuminates indicating the
module is ready to synchronize with the remote.
4. Within ten (10) seconds push the ON/OFF key on the remote. The IFC module will “beep” four (4) times to indicate that it has
successfully synced with the remote. Turn the fireplace OFF using the ON/OFF button on the remote to complete initialization. The
remote will now control the fireplace.
5. Install the provided four (4) AA batteries into battery back up holder.
Turn "ON" the Appliance
With the system OFF, press the ON/OFF Key on the
Remote. The Remote display will show other active
icons on the screen. At the same time the Receiver
will activate the appliance. A single “beep” from the
receiver will confirm reception of the command.
Turn "OFF" the Appliance
With the system ON, press the ON/OFF Key on the
Remote. The Remote display will show the current
room temperature. At the same time the Receiver
will turn the appliance off. A single “beep” from the
receiver will confirm reception of the command.
Figure 19.4.04:
Figure 19.4.05:
Battery Compartment Proflame II IFC Module