7
Installation
5. 0 In s t a l l a t i o n C h e c k l i s t
Th i s s t a n d a r d i n s t a l l a t i o n c h e c k l i s t i s t o b e u s e d b y t h e i n s t a l l e r i n c o n j u n c t i o n w i t h , n o t i n s t e a d o f , t h e i n s t r u c t i o n s c o n t a i n e d
w i t h i n t h i s i n s t a l l a t i o n m a n u a l .
C u s t o m e r :
Da t e In s t a l l e d :
In s t a l l Ad d r e s s :
Lo c a t i o n o f Fi r e p l a c e :
In s t a l l e r :
Solid Fuel Zero Clearance Install: (Section 9.1)
Y ES
NO
IF NO, W
HY NOT?
Was the bottom of the existing zero clearance firebox removed?
Was a 0.15" (3.8 mm) minimum clearance maintained as shown in
Fi g u r e 9 . 1. 02
?
Venting: (Section 13.0)
Y ES
NO
IF NO, W
HY NOT?
Venting configuration complies with vent diagrams.
Venting installed, fastened, and secured in place maintaining proper
clearances.
Secured or removed existing solid fuel fireplace damper.
Terminations installed and sealed in compliance with local building
code.
Direct vent termination is highest point in vent assembly.
Wiring / Electrical: (Section 7.0)
Y ES
NO
IF NO, W
HY NOT?
Connected to household 110/120v per local codes.
Unit is properly grounded.
Gas: (Section 11.0)
Y ES
NO
IF NO, W
HY NOT?
Proper appliance for fuel type?
Was a conversion performed?
Leak check performed & inlet and manifold pressures verified?
Was the rating of the insert clocked?
Fi n i s h i n g :
Y ES
NO
IF NO, W
HY NOT?
Only noncombustible material installed in noncombustible areas.
Clearances meet installation manual requirements.
Mantels and/or projections comply with install manual.
Was the solid fuel fireplace warning plate installed (
Fi g u r e 9 . 0. 02
)?
Ap p l i a n c e Se t u p :
Y ES
NO
IF NO, W
HY NOT?
Log set, door, and screen installed according to install manual.
Manual given to home owner.
Did you check operation of lights, fans, and flame modulation?
Does the main burner light within 4 seconds of main gas valve
opening (see
Se c t i o n 20. 1
)?
Door buckles operate freely?