70
Maintenance
18.12 Replacing the Burner
Before you begin:
•
Ensure the fireplace is off and cool before servicing
•
Ensure the gas supply is turned OFF and disconnect the power supply (including backup batteries)
•
Remove the barrier screen (see
Section 6.3
)
•
Remove Glass Door (see
Section 6.4
)
•
Remove burner media (see the
Log Set Installation Manual
)
•
Remove panel set (if applicable - see
Section 15.0
)
•
Remove the burner surround (see
Section 18.11
)
Installation is the reverse of removal. When reinstalling the burner
the holes in
Figure 18.12.05
should align.
Check operation of air shutter when reinstalling the burner.
See
Section 18.5
.
Figure 18.12.01:
Step 1:
With the burner surround removed, push the burner toward the right side of the fireplace.
WARNING: All parts removed or disturbed, including guards and grills, must be properly replaced after maintenance.
Service and repair must be conducted by a qualified service person. If these instructions are not followed, a fire
or explosion may result, causing property damage, personal injury or loss of life.
Figure 18.12.02:
Step 3:
Push the air shutter to the left so that it clears the mixing
tube.
Figure 18.12.03:
Step 4:
Lift the burner out of the fireplace.
Figure 18.12.04:
Figure 18.12.05: