Archgard 31-DVIM33C-2, Инструкция по установке, эксплуатации и обслуживанию, Страница: 20 / 40

20
Installation
Vent Restrictor Installation
When the vent is over 18’(5.5m) a vent restrictor may be required. The installation of the restrictor will equalize the vent stack action
that can cause problems with a proper fire set-up.
The vent restrictor is supplied loose in the manual bag. When required, it installs onto the upper baffle in the center portion. The baffle
air openings are located in the top of the firebox just inside the front frame of the fireplace. There are holes already in the standoffs that
will line up with the holes in the restrictor.
Surround Installation
Surround options available are dependent upon the control panel
configuration. (See Control Panel Locations regarding configura -
tion.) Shallow surround options are not available on a unit with
‘Controls Out’ configuration.
Make sure the gas and electrical lines are properly connected to the
appliance. Slide the unit into the fireplace and slide the excess flue
liner material back onto the chimney. Before the appliance is fully
recessed into the fireplace, attach the surround onto the appliance.
Attach the surround to the appliance at the locations shown by
lining up the tabs on the surround with the slots on the unit. Make
sure the surround drops down and fully engages. Then finish with
the wiring connection to the on/off switch on the side of the trim.
Now fully “seat” the unit into its final position.