Archgard 31-DVIM33C-2, Инструкция по установке, эксплуатации и обслуживанию, Страница: 17 / 40

17
Installation
Venting Instructions 999-INS-TK
Install the termination cap making sure to provide sufficient space (around and on top) so you do not impede
the flow of air, both into and out of, the cap. This cap is only to be used for non-combustible installations. Do not
recess into the top of the chimney.
1. Mark each end of one flex liner with “ Air Intake ”.
2. Mark each end of the second flex liner with “ Exhaust ”.
3. Pull the liner through the chimney.
4. Install the flashing.
5. Seal and attach the flex liner marked “ Air Intake ” to the vent terminal pipe marked “ Air Intake ” with the collar clamp
and stove cement provided with the kit. DO NOT USE SILICONE.
6. Seal and attach the flex liner marked “ Exhaust ” to the vent terminal pipe marked “ Exhaust ” with the collar clamp and
stove cement provided with the kit. DO NOT USE SILICONE.
7. Seal and attach the end of the flex liner marked “ Air Intake ” to the collar marked “ Air Intake ” on the appliance with
the collar clamp provided with the appliance and stove cement provided with the kit. DO NOT USE SILICONE.
8. Install the exhaust vent restrictor provided (if applicable), See Pg.16, Seal and attach the end of the flex liner marked
“ Exhaust ” to the collar marked “ Exhaust ” on the appliance with the collar clamp provided with the appliance and
stove cement provided with the kit. DO NOT USE SILICONE.
Use of silicone voids the warranty of the pilot assembly .
9. Attach the termination head to the termination body using the stove cement and screws provided with the kit.
NOTE: The flex liners must form a complete connection from the appliance flue collars to the vertical termination cap.
The minimum flue (chimney) size required to run the two 3" (76 mm) is 4" x 7" (100 mm x 178 mm).