Archgard 22-DVI24N-3, Инструкция по установке, эксплуатации и обслуживанию, Страница: 24 / 44

22-DVI24N-3 24
GLASS DOOR REMOVAL
CAUTION: Do not attempt to remove the glass door when the appliance is hot .
1. Remove the TOP louver by pulling the entire louver assembly towards you.
2. Open up the BOTTOM louver assembly to expose the control valve.
3. Locate the 2 buckle latches under the glass door frame (Fig.1) and pull down the lever on
the back of the latches to release them.
4. Unhook the latches from the bottom of the door and swing the bottom of the door towards
you - then lift up on the whole door to unhook the top of the door. Carefully remove the
door and put it away at a safe location where it cannot be scratched or damaged.
Replacing the Glass Door
The reverse procedure of Removing the Glass Door.
IF YOUR GLASS BREAKS
WARNING : Do not operate appliance with the glass front cracked or broken. Replacement of
the glass should be done by a licensed or qualified service person.
.
Fig. 1
LOCATING TABS
(UPPER LOUVERS
REMOVED)
DOOR LATCHES
(SHOWN OPEN)
In the event your glass cracks or breaks, replace the original door assembly with an Ambiance replacement
door assembly (part number 841 - 0086). The glass door and frame assembly must be replaced as a complete
unit. Remove the barrier screen and remove door as per the instructions above. Replace with new door
assembly and reinstall the barrier screen.
NOTE: the NEW door will emit some odor when the appliance is lit. The odor will dissipate after the gasket
material within the door has cured. Be sure there are no fingerprints left on the glass panels as high
temperatures can bake these prints on permanently.